We get asked this a lot. The short answer is, yes we can
supply car seals for locking valves in any length. However, as they’re made to
order, you can often wait 4-6 weeks and, naturally the price increases because
often the quantity required is much less.
But there is another way. It’s easy enough to shorten the
cable length but it’s important that you do this after the cable has been
applied to the valve. This is because when you cut the cable, the ends fray
out, making it impossible to thread the end through the hole in the car seal
body. See photo.
Or if you prefer not to cut the cable, simple tie the
surplus cable in loose knot loops, like in the photo.
Car Seals are widely used in process industries to lock
(seal) valves in the open or closed position. They are a low cost means to
effectively prevent inadvertent or accidental operation of critical process
valves. When used as part of a car seal program you can record the status of
valves throughout your plant. When it’s time to operate the valve, just cut the
cable and discard the seal. The materials of construction are fully recyclable.
Visit www.car-seal.com to view our full range of Car Seals.
No comments:
Post a Comment